Angled TRRS Connector
This Gold&Nickel angled TRRS connector is a 4-pole, 3.5mm gold-plated connector. It consists of only two parts and will work perfectly on any cable build or DIY project.
Model: Angled TRRS Connector – Gold & Nickel
Pieces: 2 pieces
Color: Gold and Nickel
Please contact us if you require more than 20 connectors.
This angled TRRS connector is a 4-pole, 3.5mm gold-plated connector. It consists of two parts, namely the shell and the connector. When you remove the shell from the connector, you will find four solder points for your wires to be soldered on. When using our USB cable, you can twist the shielding and drain wire together and use this instead of the black wire for your cable’s ground. If you are using the shielding and drain wire for your cable’s ground, you can cut off the black wire. We suggest using either heatshrink or electrical tape to insulate the power and two data wire’s solder points. You will have to be very careful not to use up too much space in this area, as it will make it difficult to screw on the shell afterward.
Always make sure the shell is on the cable and the right way around before you start soldering. You will be very disappointed when you finish soldering the connector on the cable and then realize you have to remove it again to slide on the shell.
Read more on our Resources page.
Only logged in customers who have purchased this product may leave a review.